B9R-1-Red

Resin Properties

Density 1.10 – 1.12 g/cm3 @ 25C/77F

Viscosity 220 – 250 cps @25C/77F

Color – Red

Shore D – 70 (fully post-cured)

Ignition temperature (for direct to sacrificial casting) 330 – 370C, (fully post-cured)

Best Practices

Storage: Store in tightly closed containers designed for light sensitive material . Store product indoors at temperatures above 0C/32F and below 38C/100F. Avoid prolonged storage temperatures above 38C/100F.

Protection: Always use protective eyewear and gloves when handling liquid resin and cleaning up newly created objects.

Use: If resin has sat for an extended time, shake thoroughly before use to ensure pigment is well dispersed, allow 5-10 minutes before pouring for air bubbles to dissipate. When returning unused resin from the vat back into the container, use a painter's disposable "filter funnel" to remove any cured "debris" that might be in the liquid.

Part Cleanup: After the part has been detached from the build platform clean remove any uncured resin by rinsing in Isopropyl alcohol ("rubbing alcohol").

Vat Cleanup: After removing unused resin (see above), the vat may be rinsed clean with Isopropyl alcohol. Do not use abrasive cleaners or drying clothes (such as paper towels) on the PDMS coating to avoid damage (scratches or tears).

Post Cure: To reach best properties the newly created object should be post cured by placing in direct sunlight for several hours.